simonini/mazzuchelli crank

Home Forums English General questions simonini/mazzuchelli crank

This topic contains 2 reacties, has 2 deelnemers, and was last updated by AIRMECH 3 years, 5 months geleden.

3 berichten aan het bekijken - 1 tot 3 (van in totaal 3)
  • Gebruiker
  • #803122

    AIRMECH
    Topic starter
    Berichten: 9

    shims or no shims in a malossi mp1 casing.?
    I noticed that thecrank already has 0.3 shoulders on the webs

    #803123

    Fredzzz
    Moderator
    Berichten: 1512

    If it’s one of the full circle cranks, then no shims are needed.

    Post pics to be sure though.

    #803131

    AIRMECH
    Topic starter
    Berichten: 9

    Measured casings and cranks and figured it out,took a bit of time to get the Exhaust and transfer timings I wanted as the rod length is also 4mm longer but all good now,now to tune the DEPS cylinder😀
    crankcase machining done and 19mm phbg carb reamed out to 21mm

    • Deze reactie is gewijzigd 3 years, 5 months geleden door AIRMECH.
3 berichten aan het bekijken - 1 tot 3 (van in totaal 3)

Je moet ingelogd zijn om een reactie op dit onderwerp te kunnen geven.