Home › Forums › English › General questions › Adapter to fit a 10pin piston on 12pin crankshaft › Reageer op: Adapter to fit a 10pin piston on 12pin crankshaft
27 december 2010 om 10:34
#145983
Daffy#46
Could you tell me the measures?
Then i will check if i can get those Needlelayers 😉
Edit: I’ve Checked it with these measures:
Asgap: 10mm
Outside: 12mm
I can’t get those Needlelayers, and i think it will be hard to find those, because 1mm on each side is not much. I only can get with an Outside Measure of 14mm, thats 2mm on each side.